The aim is to establish the maximum distance

The aim is to establish the maximum distance traveled by a rubber band under a constant release strength. To shoot a rubber band as far as possible. How does the angle of release affect the distance traveled? Hypothesis When the angle of release is increased, the distance will increase up to 45 degrees which is the optimum, and it will decrease after 45 degrees. Constants/Variables Constants – Height of Release (60cm from the ground) – Length of extension of the rubber band (25cm) – Use of the same rubber band for the entire experiment Variables.- Angle of Release (from 0 degree to 75 degrees with 15 degrees increments) Apparatus Measuring tape, Ruler, Protractor, Rubber band Method 1. Set down the measuring tape first.

2. Measure each of the angles of release with protractor, from 0 degree to 75 degrees. 3. Release it at 60cm from the ground with an extension of 25cm.

We Will Write a Custom Essay Specifically
For You For Only $13.90/page!


order now

4. Repeat it three times for each angle. 5. For each angle, if the data is considerably higher or lower than the other measurements, ignore it and do it once more to obtain more accurate data. Data Collection & Data Analysis Angle of Release Distance traveled (m)In degrees Trial  Conclusion & Evaluation As you can see from the graph, releasing the rubber band at an angle of 45 degrees provides the greatest distance, we can call the optimum.

It gradually increases from 0 degree and at 45 degrees, has the greatest distance, and it decreases afterwards. The reason why the rubber band travels the furthest at an angle of 45 degree is because it is closer to the parabolic curve.During the experiment, certain measurements were really off the mark. For example, when measuring for the angle of 15 degrees, a result of 6 meters was recorded while the probable range was near 4 meters. There is no clear explanation for that but it seems that the release strength may not have always been constant.

It is also possible that during the experiment some settings like height and angle of release may have been inadvertently modified by the operator. It would therefore be advisable to do more than 3 trials for each release angle in order to obtain more accurate data.

x

Hi!
I'm Simon!

Would you like to get a custom essay? How about receiving a customized one?

Check it out